Environmental guidance for your business in Northern Ireland & Scotland
If you pollute the water environment, you are probably committing an offence.
In Northern Ireland you must have consent from the Rivers Agency before you place structures in any waterway that are likely to affect its drainage. Contact your local Rivers Agency office for further information.
DAERA has produced a handbook is for landowners and people and organisations involved in carrying out activities that may alter the physical characteristics or flows of rivers and other waterbodies. The activities covered include dredging and substrate addition, removal of bankside vegetation, bed and bank reinforcements, flow manipulation and culverting.
In Scotland, if you carry out building and engineering works in inland waters or carry out activities close to waters that could significantly affect the water environment, you must either:
Any static plant or machinery used within 10m of any:
must be placed on a suitable drip tray with a capacity equal to 110% of the capacity of the fuel tank that supplies the equipment. You must make sure that the equipment you use does not leak oil.
Empty drip trays regularly to make sure that they can contain any spills.
Guidance for Pollution Prevention (GPP) 5 contains guidance on measures you can take to avoid causing pollution during building and engineering work.
You may be committing an offence if you allow a watercourse to become blocked or polluted. The following good practice guidance will help you avoid this.
Consult your environmental regulator and your water company or water authority at the planning stage to check if there are any water protection measures for your site that you must comply with.
Construct silt traps or other forms of sediment control in areas where there is a high risk of erosion. Fine sediments such as clay, silt and fine sand can have an adverse affect on flora and fauna, such as blocking the gills of fish and preventing light from reaching the leaves of plants. Coarse sediment can have a serious impact on fish spawning grounds and can block channels in rivers and streams.
Install collector drains immediately after cultivation especially where large volumes of run-off could reach a forest road.
Collector drains should not end close to a watercourse. Ideally they should end on flat ground to allow sediment-laden water to fan out and soak away. You should protect watercourses and the surrounding vegetation by establishing a buffer area, a zone of undisturbed vegetation between the cultivation area and the watercourse.
When deciding the width of the buffer area around a stream you should consider:
If your supplier has treated your planting stock with insecticide, you must not store or soak it in a watercourse before you plant it.
Trees, especially conifers, can capture and transfer atmospheric pollutants to surrounding ground. This can cause the acidification of surface waters, especially in upland forests. This can prevent successful fish spawning and can cause damage to a number of plants, including sphagnum mosses in upland bogs.
Speak to the Forestry Commission or Forest Service Northern Ireland when planning your planting operation. They will be able to help you identify which areas are most at risk.
If you produce Christmas trees you will need to shape trees by pruning and shearing to maximise their selling potential. Keep streams free from cut branches as far as possible.
Lifting is the term used to cover all methods of removing (felling or digging) young trees from the ground either by hand or by machine.
When you remove or lift young trees from the ground, you are likely to cause silty water run-off. This could pollute nearby rivers or streams.
If your site is prone to erosion, only work during spells of dry weather to reduce run-off.
Inspect local watercourses regularly for evidence of discoloration or sediment build-up, particularly at the drainage outlets in plantation sites. Install sediment traps if you find signs of pollution.
If you are harvesting in a water supply catchment area you should contact your water company or water authority. They will want to make sure that your work is not affecting the water supply.
After harvesting, make sure that you clear drains and natural watercourses of any blockages that have occurred.
Before you begin work, you must check to see if there are any protected species such as otter and water vole in any streams or watercourses close to the site where you intend to harvest.
If you find or suspect that protected species are there, you must change your felling plans to protect their habitat and limit any disturbance.
Keep streams and buffer areas free from harvested branches and tops.
Consider cableway extraction for sensitive sites and catchment areas.
If you plan extraction routes on steep slopes, dig shallow cross ditches to reduce water movement and erosion.
Create adequate brash mats and maintain their structure.
Fell trees away from watercourses to reduce the risk of brash and logs causing blockages and disturbing freshwater habitats.
The Northern Ireland Environment Agency has published a short guide to the duty of care responsibilities including advice and information for waste producers, carriers and those accepting, storing and treating waste.
Any person intending to alter the use or management of areas of uncultivated or semi-natural land must obtain prior approval from the Department of Agriculture, Environment and Rural Affairs (DAERA).
Read more on the DAERA website
The NetRegs team at SEPA, in partnership with The Northern Ireland Environment Agency, Natural Resources Wales and a number of industry bodies have produced 9 new GPPs to replace out of date PPGs. More are coming! Check the available topics
View our latest videos & subscribe to our channel.
Free monthly email newsletter with environmental updates for Northern Ireland and Scotland